VTech CS5111 Uživatelský manuál

User’s manualw w w.v t e c h p h o n e s . c o mModels: CS5111/CS5113

7 When there is a power failure, the time may need to be reset.•Date and time If you subscribe to caller ID service, the date and time is set automati

8Telephone settingsRinger volume (continued)4. Press SELECT to conrm your selection. You will hear a conrmation tone.-OR- Press and h

9Telephone settingsLanguage Press PROG when the handset is not in use.Press or until LANGUAGE is displayed. Press SELECT. The current setting as

10VolumePress /VOL-/CID or /VOL+/ to adjust the listening volume during a conversation.ChannelPress CHAN/REMOVE to switch to a clearer channel whil

11Telephone operationRedialThe telephone stores the ve most recently dialed telephone numbers in the redial list. When the list is full, the oldest e

12Telephone operationCharacter chartUse the dial pad keys and the chart below to enter a name (up to 14 characters). An error tone sounds if you try t

13Telephone operationEdit a directory entry (continued)When the screen displays the desired entry, press SELECT and EDIT ashes.Press SELECT. The scre

14Telephone operationCopy a directory entry into speed dialPress /VOL+/ when the handset is not in use. The screen displays DIRECTORY.Press or t

15Telephone operationStore a speed dial entry (continued)Use the dial pad keys to enter the name (see the Character chart on page 12) and then press S

16Telephone operationDelete a speed dial entryPress and hold the speed dial location key (1-9) of the desired entry when the handset is not in use.Whe

Before using this telephone, please read the Important safety instructions on page 22of this manual.For support, shopping, and everything new at VT

17Telephone operationCall logIf you subscribe to caller ID service, information about each caller will be displayed after the rst or second ring.The

18Telephone operationMake call log entries ready to dialAlthough the call log entries received have 10 digits (the area code plus the seven-digit numb

19Telephone operationSave a call log entry to the directory (continued)5. Enter or edit the name if necessary. See the Character chart on page 12.Pre

20Displays: When:LOW BATTERYThe battery needs to be recharged.CID EMPTY There are no call log entries.CONNECTING...

21AppendixDisplays: When:LOW BATTERYThe battery needs to be recharged.CID EMPTY There are no call log entries.CONNECTING...

22AppendixImportant safety instructionsWhen using your telephone equipment, basic safety precautions should always be followed to reduce the risk of 

23AppendixTroubleshootingIf you have difculty with your telephone, please try the suggestions below. For Customer Service, visit our website at www.v

24AppendixTroubleshootingThe talk time and standby time of my handset is noticeably shorter than before.Completely charge and drain the battery two or

25AppendixTroubleshootingI cannot dial out.First, try all the above suggestions.Make sure there is a dial tone before dialing. It is normal if the han

26AppendixTroubleshootingI hear noise in the handset, and none of the keys or buttons work.Make sure the telephone line cord is plugged in securely.Re

Table of contentsiiGetting started . . . . . . . . . . . . . . . . 1Parts checklist . . . . . . . . . . . . . . . . . 1Telephone base installation . .

27AppendixTroubleshootingOther electronic products can cause interference to your cordless telephone. Try installing your telephone as far away from t

28AppendixCommon cure for electronic equipmentIf the unit is not responding normally, try putting the handset in the telephone base. If it does not re

29AppendixOperating rangeThis cordless telephone operates with the maximum power allowed by the Federal Communications Commission (FCC). Even so, th

30AppendixWarrantyWhat does this limited warranty cover?The manufacturer of this VTech Product warrants to the holder of a valid proof of purchase (“C

31AppendixWarrantyOther limitationsThis warranty is the complete and exclusive agreement between you and VTech. It supersedes all other written or ora

32AppendixFCC, ACTA and IC regulationsFCC Part 15This equipment has been tested and found to comply with the requirements for a Class B

33AppendixFCC, ACTA and IC regulationsIndustry CanadaOperation is subject to the following two conditions: (1) this device may not cause harmful inter

34AppendixTechnical specicationsFrequency control Crystal controlled PLL synthesizerTransmit frequency Handset: 5857.20-5865.90 MHzTelephone base: 91

35AppendixFrequency control Crystal controlled PLL synthesizerTransmit frequency Handset: 5857.20-5865.90 MHzTelephone base: 912.75-917.10MHzChannels

36AppendixIndexTTechnical specications 34Telephone base installation 2Telephone base layout 6Telephone operation 10Telephone settings 7Temporary

1Parts checklistYour telephone contains the following items. Save your sales receipt and original packaging in the event warranty service is necessary

VTECH TELECOMMUNICATIONS LTD.A member of THE VTECH GROUP OF COMPANIES.Distributed in the U.S.A. by VTech Communications, Inc. Beaverton, Oregon 97008D

2Telephone base installationIf you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must ins

3Getting startedBattery installation and chargingInstall the battery as shown below. The battery may have enough charge for short calls and then compl

4Getting startedWall bracket installation (continued)Wall bracket installation:First, insert the lower portion tabs of the wall bracket into the lower

5Getting startedOPERD E FJK LPQRSWX Y ZTUVMNOTO NEA BCCHARGE/VOL-/CID• When the telephone is not in use, press to review the call log.• Press and

6Getting startedTelephone base layoutFIND HANDSET Press to page the handset.•IN USE lightFlashes when there is an incoming call.On when the handset is