Vtech Dect 6.0 DS6211-4 Uživatelský manuál stáhnout pdf (Strana 34)

Appendix

Replace a handset

If you want to replace a handset or re-assign the designated handset number

of a registered handset, you must de-register all the handsets and then

individually register each handset.

To make de-registration easier, read all of the instructions on this page before

you begin. To de-register all handsets:

Press and hold FIND HANDSET on the telephone base for about 10

seconds (until the IN USE light on the telephone base turns on and starts

to ash), then release FIND HANDSET.

Press and release FIND HANDSET again. You must press

FIND HANDSET while the IN USE light is still ashing. The IN USE light

ashes for approximately seven seconds.

All system handsets show CONNECTING... The de-registration process

takes about 10 seconds to complete. All handsets show

NOT REGISTERED when the de-registration completes.

If de-registration fails, reset the telephone and try again.

To reset:

Pick up the registered handset and then press .

Press OFF/CLEAR and place the handset back in the telephone base.

-OR-

Unplug the power from the telephone base, then plug it back in.

You cannot de-register a handset if any system handset is in use.

To re-register a handset, see Add and register a handset on the

previous page.

•

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

Žádné komentáře

Vtech Dect 6.0 DS6211-4 Uživatelský manuál Strana 34