VTech IS7121 Instalační příručka

1Installation guideIS7121/IS7121-2/IS7121-22DECT 6.0 cordless telephone with wireless doorbellBefore using this product, read this Installation guide

10Loosen the screws and the metallic plates, then slide the metal part of the wires underneath the metallic plates as shown. Twist the screws to secur

11Push the doorbell gently onto the wall mount until they are sealed tightly.This doorbell meets the IPX4 waterproof standard. Make sure the doorbell

12DOORBELL INSTALLATION COMPLETED! Refer to the Abridged user’s manual for common settings and operations. Plug the adapter into the indoor domestic

13After an extended exposure to cold, heat or humidity, the doorbell gasket rubber may become sticky.If you need to remove the doorbell from its wall

14If you already have a wired doorbell installed, follow the instructions below to install your new IS7121 doorbell unit.Turn off the power supply to

15Option 1: Ring the front doorbell of the existing wired doorbell and the IS7121 doorbell simultaneously.Using another wire, slide o

16Option 2: Ring the rear doorbell of the existing wired doorbell and the IS7121 doorbell simultaneously.Follow Step 6 to Ste

21Install telephone base & chargerPlug!Click!Plug!DSL lterClick!Plug!

32Install handset batteryBattery PackBT164392/BT2643922.4V 550mAh Ni-MHWARNING : DO NOT BURN ORPUNCTURE BATTERIESMade in China CR1222

43Install wall mount bracket (optional)1Unplug!Unplug!23Plug!Click!4Slide the bracket down!

54Install doorbell batteryBASIC INSTALLATION COMPLETED! Keep reading for doorbell location testing.The doorbell can be supported by AC power only. Se

618 inches50 degrees63 inches20 inchesShooting areaAvoid mounting it to where it is exposed to direct sunlight.Avoid mounting it to where reections m

7DOORBELL LOCATION TESTING COMPLETED! Keep reading for doorbell wall mount installation.To adjust the shooting area, you may either relocate the doorb

86Doorbell wall mount installationMake sure you have done Step 5 above before you mount the doorbell on the wall. If you drill the holes into a stud,

9Use a sharp object to open a hole on the soft plastic part on the doorbell wall mount cover, then route the power adapter cord through the hole.4.Ali